Total secure addresses on interface reached its max limit of

I’m trying to simulate a violation and put f0/2 to shutdown state. Everything is set up correctly but I do not know what is happening:

SW4(config-if)#do sh run int f0/2
Building configuration...

Current configuration : 254 bytes
!
interface FastEthernet0/2
 switchport access vlan 20
 switchport mode access
 switchport port-security
 switchport port-security mac-address sticky
 switchport port-security mac-address sticky 00e0.4c8b.116f
 no ip address
 spanning-tree portfast
end

When I connect a different device instead of “err-disabled state” i get:

%Error: Cannot add secure address 5442.49f8.7b80
%Error: Total secure addresses on interface reached its max limit of 1

It seems that the switch (3550) that I’m working on can’t update the MAC address, it says configured MAC addresses: 0.

SW4(config-if)#do sh port int f0/2
Port Security : Enabled
Port status : SecureUp
Violation mode : Shutdown
Maximum MAC Addresses : 1
Total MAC Addresses : 1
Configured MAC Addresses : 0
Sticky MAC Addresses : 1
Aging time : 0 mins
Aging type : Absolute
SecureStatic address aging : Disabled
Security Violation count : 0

I wanted to see past commands that I have typed but I’ve had only 10 of them, because the history size is set to 10 by default. Here is how to set the history size !
And I have no errdisable for recovery mode:

SW4#sh errdisable recov
ErrDisable Reason    Timer Status
-----------------    --------------
udld                 Disabled
bpduguard            Disabled
channel-misconfig    Disabled
pagp-flap            Disabled
dtp-flap             Disabled
link-flap            Disabled
l2ptguard            Disabled
psecure-violation    Disabled
gbic-invalid         Disabled

Timer interval: 300 seconds

Interfaces that will be enabled at the next timeout:

Leave a Reply

Your email address will not be published. Required fields are marked *


+ eight = 11